Create Plant

This section describes the procedure of creating plants through the App.

The plant creation screen may slightly vary with plant type, inverter type, and communication device. For details, refer to the actual screen.

Prerequisites
Introduction

The end user assigns the plant to the distributor/installer for management and gets the distributor/installer code from the distributor/installer.

The distributor/installer who creates a plant for the end user needs to get the end user’s e-mail address.

In creating a plant, the e-mail address is required, and each e-mail address can be registered only once.
Procedure

If there is no plant in the account, tap “Create Plant”. If there is a plant in the account, tap 创建电站的图标 to enter the “Create Plant” interface.

Fill in Basic Plant Information
Parameter name Description
*Plant name The plant name is the device SN by default
*Plant type Tap to select corresponding plant type
*Installed power(kWp) Enter the installed power
*Country (region) Tap to select the country (region) of the plant
*Time zone Tap to select the time zone of the plant
*Plant address The plant address can be added in two ways:
Manual entry: enter the plant address manually in the input box;
Automatically access:tap to get the current location or search the plant address automatically.
*Grid-connection type Tap to select the grid-connection type of the plant
Grid-connection date Tap to select the grid-connection date
*Owner email address/phone number Enter the owner’s email address or phone number
Postcode The postcode where the plant is located
Plant picture Tap to upload the plant picture
Feed-in tariff and consumption tariff 1. Enter the feed-in tariff
2. Tap “More configurations”:
a. Enter the tariff unit
b. Enter grid tariff or turn on time-of-use tariff and fill in the grid tariff in different time segments

Note:

  1. *indicates required fields.
  2. The time zone of the plant and the plant address are automatically obtained when “Creat Plant” is tapped.
Add Communication Device
  1. Scan the QR code on the communication device or identify the QR code picture. Tap “Confirm” to add the device.

  2. Select a communication device type and view the serial number of the device in the lower part of the interface. Manually enter the S/N of the communication device and click “Confirm” to add the communication device.

System Debugging

When the communication device is successfully added, the device interface is displayed by default.